Skip to content

Truck Mixer Drum Rollers and Bearings: When to Replace and How to Find the Size

Rollers are the parts nobody notices until the drum starts to make a noise. This guide helps you spot wear early and order the right size the first time.

Published

Mixer drum roller with pin

What the drum rollers do

The rollers carry the drum while it turns. They rub against the drum's track and take the heavy concrete load every day. The catalogue lists them as “Drum Roller” with measurements in the name, and some come complete with the pin (With Pin). You will find them under mixer and batching-plant parts.

Signs of wear

  • A grinding or knocking noise while the drum turns.
  • Unusual vibration in the drum or frame.
  • A roller that does not turn freely, or has a flat spot or uneven wear.
  • Grease leaking or signs of heat at the roller.

If these signs are ignored, the neighbouring roller or the drum track can be damaged, which costs far more than replacing a roller.

How to find the size

What to sendWhy
A photo of the old roller and its pinShows the shape, the fixing method and whether the roller comes complete or with its bearing.
Three measurements in millimetresThe catalogue name carries three numbers, such as “Drum Roller 280X110X50”. Measure the old roller the same way and send the numbers, and we confirm which number matches which dimension.
Mixer make, model and yearTo confirm the match before you order.
The quantityOne roller or more. Rollers are often replaced in pairs so wear stays even, but inspect each one.

See also how to find the part number and how to order.

Bearings and the hydraulic motor

The bearing number is printed on its ring, and bearings are under bearings. If the drum is slow or the noise comes from the drive end, the cause may be the hydraulic motor or pump rather than the rollers. The catalogue has codes such as A2FM80 and A4VTG90 used in mixer drives, explained in hydraulic pump and motor codes.

Parts from the catalogue

Related categories

Quick questions

Should I replace both rollers together?

Often it is better, so wear stays even, but inspect each roller and send photos of both so we identify what you need.

Can I replace only the bearing?

It depends on the roller's design. Some rollers are sold complete with the pin. Send a photo and we tell you the available option.

What do the three numbers in the roller name mean?

They are measurements in millimetres. Measure the old roller in all three and send them, and we confirm which number matches which dimension before you order.

Do you supply rollers for every mixer make?

We do not promise that. Send the mixer make and model and a photo of the roller and we reply with what we have.

Read next