Skip to content

Concrete Pump Wear Parts: What Wears Out and When to Replace It

Concrete is abrasive, and some pump parts wear out by design. Knowing these parts and the signs of wear helps you replace them before the pump stops on site.

Published

Wear plate and cutting ring

How the pumping end works, in short

In most truck-mounted pumps, a piston in one delivery cylinder draws concrete from the hopper while the S-valve swings to connect the other cylinder to the delivery line. The spectacle plate and cutting ring at the hopper outlet are what the S-valve seals against as it moves, so they take the most rubbing.

The parts that wear out

  • Spectacle plate (wear plate) and cutting ring: normally replaced together.
  • S-valve: wears from the inside as concrete passes through, so check its wall thickness.
  • Delivery pistons, their rubber rings and the delivery cylinders: the rings wear and scoring appears on the cylinder wall.
  • Delivery pipes, elbows and the end hose: the wall thins most at the bends, and the end hose wears at the discharge end.
  • Seals and bearings in the agitator, the S-valve swing joint and the hydraulic cylinders.

Signs that it is time

  • Less concrete pumped, or pressure that builds slowly.
  • Concrete or slurry leaking around the hopper outlet and cutting ring.
  • Water in the water box turns cloudy or grey: cement is getting past a worn piston ring.
  • Scores or grooves on the delivery cylinder wall.
  • A rough or jerky S-valve swing, or a grinding noise.
  • Pipes or elbows with thin spots, bulges or leaks.

What makes parts wear faster

  • The mix: coarse, sharp aggregate scrapes more.
  • Pumping pressure and long distances.
  • How well the pump is washed out after work and how often the water box water is changed.
  • Leaving a worn part in service: a worn cutting ring, for example, damages the wear plate.

Part life varies a lot with these factors, so regular inspection is better than relying on a fixed number of hours.

Order the set, not a single part

  • When you change the spectacle plate, change the cutting ring with it.
  • Change the rings of both pistons together so they perform equally.
  • If you have the unit open, check the S-valve and agitator seals and bearings at the same time.

Send the part numbers or photos on WhatsApp at +966 59 211 2782 and we reply with the price and availability.

Parts from the catalogue

Related categories

Quick questions

Should I replace the spectacle plate and cutting ring together?

Usually yes. A worn cutting ring damages a new spectacle plate, so they are replaced together.

How do I know the piston rings are worn?

If the water box water turns cloudy or grey, cement is getting past the rings. That is a sign of wear.

Read next