Skip to content

Spectacle Plate and Cutting Ring: Signs of Wear and When to Replace Them

These two parts are made to wear so that they protect the S-valve and the hopper. Knowing the signs of wear saves you a pump stop on site.

Published

Red spectacle wear plate

What the two parts do

The spectacle plate is a hardened plate fixed at the hopper outlet, and the cutting ring sits on the S-valve inlet and slides against it. The ring seals the path and shears the concrete column, so the two rub on each other and on the concrete with every stroke. That is why they are among the first parts replaced. You will find them under wear parts.

Signs of wear

  • Slurry (water and cement) leaking or spraying at the joint between ring and plate.
  • Lower output although the concrete, the line and the oil are fine. See also slow or weak output: possible causes.
  • Grooves, steps or a dished surface on the sliding face instead of a flat one.
  • A crack, chip or worn edge on the ring or plate.

Why they are replaced together

A new ring on a worn plate does not seal well and wears fast, and a new plate with an old ring wears the same way. That is why the two are normally replaced together. At the same time, check the thrust ring that keeps the S-valve seated against the plate, the wear sleeve and the seals in the S-valve housing.

What to send us so we identify the part

What to sendWhy it matters
Pump make and modelThe plate and ring are made per model and size and do not swap between models.
Stamped number or sizeIn the catalogue the size is in the name, such as “Cutting Ring 210” or “Wearing Insert 230”, and we match it to your pump.
A front photo of the old pairShows the wear pattern, the number of openings and the fixing method.

Send them on WhatsApp as in how to order. For Putzmeister see Putzmeister spare parts in Riyadh, and for Schwing Schwing spare parts in Riyadh.

Parts from the catalogue

Related categories

Quick questions

How long do the spectacle plate and cutting ring last?

There is no honest figure that fits everyone. Life depends on the mix, the aggregate and the volume pumped, so inspect them regularly and replace them when the signs appear.

Can I replace only the ring?

It is possible, but replacing the ring and plate together is better, because a new part wears quickly against a worn one.

Do you supply these parts for Putzmeister and Schwing?

The catalogue lists plates and rings for Putzmeister and Schwing pumps. Send the pump make and model or a photo of the part and we confirm the match.

What else should I check when replacing them?

The thrust ring, the wear sleeve and the seals in the S-valve housing, because they work with the plate and ring and wear in the same conditions.

Read next